高壓清洗機的沖洗能力強，能去除地面等物體表面的污垢與油污漬等。小編特地整理一份高壓清洗機的使用說明，方便大家隨時隨地查詢。高壓清洗機的使用說明如下：

High pressure washing machine has strong washing capacity, and can remove dirt and oil stains on the surface of objects such as the ground. I specially compiled a manual for the use of high-pressure cleaning machine, which is convenient for you to inquire at any time and anywhere. The operating instructions of the high-pressure washer are as follows:

1、接好高壓清洗機的電源開關；

1. Connect the power switch of the high-pressure washer;

2、通電時，主要要把噴槍打開，避免出現回流水現象和機器發熱；

2. When the power is on, the spray gun should be turned on to avoid backflow water and machine heating;

3、初次使用高壓清洗機時，使用夠20個小時后更換機油（機油用摩托車機油就可）；

3. When using the high-pressure washer for the first time, change the engine oil after 20 hours of use (motorcycle engine oil is enough);

4、第二次以后，使用100個小時后更換一次機油；

4. After the second time, replace the engine oil after 100 hours of use;

5、沖洗時，壓力慢慢加大，不要一次加到大，以避免機器發熱；

5. During flushing, the pressure shall be increased slowly, not at one time, to avoid heating of the machine;

6、冬天使用時，注意要涂防凍液；

6. When using in winter, pay attention to applying antifreeze;

7、加機油時，注意加油量，加到油缸規定紅線稍高就可；

7. When adding oil, pay attention to the amount of oil, and add it to the specified red line of the oil cylinder slightly higher;

8、沖洗時，切忌將水槍對著人，以避免傷人；

8. When washing, never point the water gun at people to avoid injury;

9、間歇式?jīng)_洗時，停槍的時間不要超過2分鐘，以避免回流、機器發熱；

9. During intermittent flushing, stop the gun for no more than 2 minutes to avoid backflow and machine heating;

10、停機時，注意先關電源。

10. When shutting down, turn off the power first.

CNC高壓清洗機日常操作與使用說明的相關內容我們就講解到這里了，您對此有什么想咨詢的問題就來我們網站www.zjfsmy.com咨詢看看吧！

This is the end of the daily operation and use instructions of the CNC high-pressure washer. If you have any questions, please come to our website www.zjfsmy.com for consultation!