高壓去毛刺清洗機作為一種物理清洗設備，因其是以高壓水射流技術為基礎的清洗設備，具備無污染、無腐蝕、低成本、率、使用范圍廣等優勢，那么他的正確操作方式是怎樣的？

As a kind of physical cleaning equipment, the high-pressure deburring washer is based on high-pressure water jet technology and has the advantages of non pollution, non corrosion, low cost, high efficiency and wide application range. What is its correct operation mode?

1.在使用高壓去毛刺清洗機進行清洗工作前，把高壓管和設備內的銹及雜質清洗干凈。

1. Before using the high-pressure deburring washer for cleaning, clean the rust and impurities in the high-pressure pipe and equipment.

2.須使用清潔的自來水直接從水龍頭連接到機器供水處，嚴格禁止水中出現沙子及其他有害雜質。

2. Clean tap water must be used to connect directly from the tap to the water supply of the machine. Sand and other harmful impurities are strictly prohibited in the water.

3.高壓去毛刺清洗機電源應為380V，50HZ，黃/綠線要求接地。

3. The power supply of high-voltage deburring and cleaning machine shall be 380V, 50HZ, and the yellow/green wire shall be grounded.

4.高壓去毛刺清洗機燃料盡量使用10#或更高品質的柴油作為燃料，油箱內不能缺油，油內嚴禁有水分和雜質。

4. 10 # or higher quality diesel oil shall be used as the fuel of high-pressure deburring washer as far as possible. There shall be no lack of oil in the oil tank, and no water and impurities are allowed in the oil.

5.須嚴格執行正確的開關程序，關時應關閉熱水，連續沖洗直到設備完全冷卻后，再關閉冷水，才是正確的操作流程。

5. The correct switching procedure must be strictly followed. The correct operation process is to turn off the hot water first, flush continuously until the equipment is completely cooled, and then turn off the cold water.

6.禁止把高壓去毛刺清洗機放置于溫度低于0攝氏度的環境中，以防止剩余水結冰，影響高壓去毛刺清洗機的使用。

6. It is prohibited to place the high-pressure deburring washer in an environment with a temperature lower than 0 ℃ to prevent the remaining water from freezing and affecting the use of the high-pressure deburring washer.

7.須保持水泵中潤滑油量，不得少于油窗中心紅點的油液面界限。

7. The amount of lubricating oil in the water pump must be kept at least less than the oil level limit of the red dot in the center of the oil window.

8.須遵循柴油濾清器保持及時調換或清洗的流程。

8. The diesel filter must be replaced or cleaned in a timely manner.

9.須遵循時常沖洗進水管中沉積下來的水垢工作。

9. Always wash the scale deposited in the water inlet pipe.

綜上所述，是使用高壓去毛刺清洗機進行清洗時的正確操作方法，操作者在使用過程中務遵循以上原則，才能使高壓去毛刺清洗機發揮出更好的作用。關注我們http://www.zjfsmy.com，了解更多！

To sum up, it is the correct operation method when using the high-pressure deburring cleaning machine for cleaning. The operator must follow the above principles in the use process to make the high-pressure deburring cleaning machine play a better role. Follow us http://www.zjfsmy.com , learn more!